APS
  • APS

GATEMASTER HYDRAULIC GATE CLOSER HINGE KIT

APS
£421.03 (Includes VAT at 20%)
  • Gatemaster
  • Hydraulic gate closer
  • Provides a controlled closing
  • Adjustable closing force
  • Weld on
  • Robust & discreet
Type
Quantity
Choose Options

100% secure payments
Average votes for this product
5.0 / 5
Average : 5.0 / 5
Based on 1 customer reviews.

GATEMASTER HYDRAULIC GATE CLOSER HINGE KIT

The hydraulic APS closer safely and reliably closes gates up to 120kg. Mounted and welded underneath the gate. The unit is therefore unobtrusive and hidden inside its own steel case. It also acts as a load-bearing lower hinge. This unit is highly vandal resistant. It can be used for right and left handed gates. It does not require any power either. The closing speed is easily adjusted using the special key provided. Due to the two separate speed adjustment valves the latching speed can be set separately to the closing speed. A fully adjustable top bracket is furthermore included. Finally the adjustable top hinge allows the gate to be correctly positioned after installation. The APSSTOP kit comes with a special built-in stop hinge which will prevent the gate from opening wider than 100 degrees. It consequently protects the closer from any damage.

Very robust unit

For gates up to 120kg

Meets ROSPA recommendations

Speed adjustable

No power required and maintenance free

Will allow a gate to be opened both ways if required and close to the centre

Optional stop hinge to prevent the gate opening wider than 100 degrees

This product offers a hold back optio. Please ask for details.

What comes in the box
QuantityItem
1GATEMASTER HYDRAULIC GATE CLOSER HINGE KIT Gate Closer
APS
2001-01-01

Data sheet

Shipping Index
Gatemaster
Fitting
Weld on
Category
Gate Closer

Specific References

upc
643570578113

Download

Product Options
Type
 
Standard Top Hinge - APS
 
 
Stop Hinge - APSSTOP
 
Submit a site survey
close

Site Survey Form

It is very important when choosing the correct automation that how much wind the gates are subject to is taken into consideration.

Safety edges are used to protect hazard points on an automatic gate. Typically they are installed in gaps of 500mm or less that reduce when the gate operates. They are made to measure and can be wired or wireless.

This is a very important part of the site survey, we cannot confirm the suitability of equipment for an application without firstly checking that the equipment suits the gates hinges and configuartion.
If your gates are not hung yet or do not exist yet then please specify that here:
If you check this box, please try to fill out at least the width and opening angle of the gate below where possible.
Otherwise please proceed with your measurements

Please feel free to upload images of your gates or site as it will greatly assist us in choosing a suitable kit.

This is the first form of its kind for us, so please let us know your thoughts and suggestions!
We would love to hear from you about it,
Thanks, the Metalines team.