S418 24v 104301
  • S418 24v 104301

FAAC S418 24v 104301

S418 24v 104301
£415.20 (Includes VAT at 20%)
Single gate motor. 24v. Max 2700mm. 500kg. Per gate.
Quantity

100% secure payments

FAAC S418 24v 104301

Looking to replace a broken FAAC S418 24v 104301. This item can be used as a direct replacement for your broken or damaged gate motor.

If you are confident that you have the correct part and model buy before 2pm for next working day delivery. subject to stock.

All of our gate motors are brand new. genuine and direct from the manufacturer here in the UK with full advice and techincal support to aid you in getting your installation back up and running.

Our friendly staff are ready to answer any questions you may have. use our live chat at the bottom of the page or call us now on 01302 327172

What comes in the box
QuantityItem
1FAAC S418 24v 104301 24v DC Motor
Motor ModelMains Power SupplyMotor VoltageMax Weight per GateMax Length per GateLocking MethodMotorGate SpeedDuty CycleNotesKITSINGLE KIT
FAAC S418 24v 104301230v24v500kg2700mmMechanically locking motorElectromechanical15 seconds 90 DegreesVery-intensiveObstacle Detection.FAAC S418 KITFAAC S418 KIT S
S418 24v 104301

Data sheet

Shipping Index
General
Power Input
35w
Gate type
Swing gate
Max weight per gate
500kg
Max length per gate
2700mm
Above or underground
Above ground
Max opening angle
110 degrees
Motor
Electromechanical
Locking method
Mechanically locking motor
Power Supply Voltage
230v
Motor voltage
24v
Gate Speed
15 seconds 90 Degrees
Duty Cycle
Very-intensive
Protection Rating
IP 54
Category
Swing Gate Motor
Submit a site survey
close

Site Survey Form

It is very important when choosing the correct automation that how much wind the gates are subject to is taken into consideration.

Safety edges are used to protect hazard points on an automatic gate. Typically they are installed in gaps of 500mm or less that reduce when the gate operates. They are made to measure and can be wired or wireless.

This is a very important part of the site survey, we cannot confirm the suitability of equipment for an application without firstly checking that the equipment suits the gates hinges and configuartion.
If your gates are not hung yet or do not exist yet then please specify that here:
If you check this box, please try to fill out at least the width and opening angle of the gate below where possible.
Otherwise please proceed with your measurements

Please feel free to upload images of your gates or site as it will greatly assist us in choosing a suitable kit.

This is the first form of its kind for us, so please let us know your thoughts and suggestions!
We would love to hear from you about it,
Thanks, the Metalines team.