CAME control boards, PCBs and control panels

Looking for a CAME control board or complete control panel? Start with the full code on the existing board and the motor label, then check whether you need a bare PCB, a boxed panel or a separate component. The products shown here also include CAME receiver cards, enclosures, transformers and other panel parts, so use the title and full reference to tell them apart.

Already have a confirmed part number? Open the matching product page and check its complete reference and what is supplied. For a radio card, browse receivers and frequency cards; for another make, see all gate control boards.

Filter products

Product Type

There are 55 products.
Showing 1-12 of 55 item(s)

PCB only or a complete control panel?

A PCB is the electronic board; a complete panel is a specified assembly, usually including an enclosure and other components. Check the individual contents rather than assuming that a transformer, terminal block, receiver card or mounting hardware is supplied. The same family name can appear on both a board-only listing and a boxed panel.

Which details identify the right CAME board?

  • Full board code and revision: keep suffixes such as ZA3P, ZM3E and ZM3EP. A similar name does not make them alternatives.
  • Motor and gate arrangement: record the exact operator, swing or sliding movement, and number of motors.
  • Electrical requirements: distinguish the incoming mains supply from the voltage delivered to the motor, including AC/DC and phase where applicable.
  • Connected equipment: note the receiver, encoder, limits, safety devices, backup and any communication modules the replacement must support.

Can a newer board replace an older one?

Sometimes. For example, CAME says the ZLX24SA enclosure footprint matches the ZLJ24 for an upgrade. That does not mean every connection, accessory or setting transfers unchanged. Check the instructions and any conversion parts for the exact old and new panels, and have the finished installation checked by a competent installer.

Is the transformer or enclosure what I actually need?

A diagnosed transformer, encoder card or terminal block may also appear in this range, but it is not a complete control board. Use its own reference to find the part. For a damaged box, see control-panel enclosures; for other power supplies and relays, see power supplies and relays.

For a different kind of replacement, continue to CAME products and support.

What should I send if I am unsure?

Send the readable motor and board references, any existing documentation and a description of the required replacement to our technical sales team. Have an installer obtain internal photographs safely. A gate that will not move does not, by itself, prove the PCB has failed; Metalines supplies equipment and specification support, not on-site fault diagnosis.