Looking for Nice gate equipment? Start with what you need: a new automation kit, a replacement motor or a part for the system you already have. Browse the routes below, or send us the full model and control-board references if you need help identifying a replacement.

Nice gate automation, motors & spares

current category:

Nice gate automation, motors & spares

Customer reviews

4.8 rating of 681 reviews
R
R. Routledge
Verified purchase
14/08/2026 12:16:08
Prompt delivery and excellent communication throughout
Good value. Prompt delivery and excellent communication throughout.
M
m. CHINN
Verified purchase
06/08/2026 12:15:03
Good update
Much better than previous versions
N
N. Davey
Verified purchase
03/08/2026 12:27:14
Perfect
Perfect replacement key, the key was reasonably priced, but the postage was too expensive
D
D. Blake
Verified purchase
19/07/2026 13:27:43
superb service
bought 3 of these locks made especially because out of stock,brilliand product but amazing service go highly recommend
R
R. LLoyd
Verified purchase
29/06/2026 09:50:12
The addition of keyfob operation
I fitted the Radio card successfully and was very straightforward.
H
H. Cook
Verified purchase
25/06/2026 15:51:30
Fabulous
Metalines have been perfect for advice support and speed of delivery. The lock itself is second to none. My joine...
W
W. Walton
Verified purchase
31/05/2026 20:26:22
Complicated for the Layman.
Complicated for the Layman, disappointing that no remotes were included as this seem like another way to disguise the...
N
N. Warnock
Verified purchase
30/05/2026 14:48:31
Gates close fine now
Gates wouldn’t close. Linked pin c1(nc) to common - opened and closed fine Replaced corroded Dir10s with these. All...
There are 99 products.
Showing 1-12 of 99 item(s)

More about Nice gate automation, motors & spares

Find the Nice equipment you need

Nice TO4024 or TO5024?

Both are 24 V TOONA swing-gate operators. Nice describes TO4024 for leaves up to 3 m and TO5024 for leaves up to 5 m. Gate weight, hinge position, opening angle and the complete installation still matter. If you are replacing a motor, keep the full code: TO5024I, TO5024HS and TO7024 are separate versions.

See the individual TO4024 motor and TO5024 motor. Building a new system? Compare the TOONA4024 twin-gate kit, TOONA5024 single-gate kit and TOONA5024 twin-gate kit. Check each listing for the number of motors, control equipment and other supplied parts.

What is Nice BlueBUS?

BlueBUS lets a compatible Nice control unit power and communicate with supported accessories, such as photocells, over two wires. The control unit identifies the connected devices during setup. Nice's BlueBUS instructions explain the connection and learning process. When replacing a photocell or control board, send us both references so we can help you find the right equipment for that system.

Already know your Nice model?

TOONA and WINGO are different swing-gate families: WG4024 and TO4024 are different motors despite the shared number. Browse the TOONA range or WINGO range. For a sliding gate, see ROBUS; for an underground swing-gate installation, see L-FAB.

Nice TUB motors and controls

If the label says TUB3500, TUB4000, D-PRO500 or MINDY A500, keep the whole reference when asking for a replacement. The motor and control equipment are different parts. Send us photographs of both labels and tell us which part you need; we can help identify the relevant Nice equipment.

Replacing a remote, photocell or control board?

Use the code on that component as well as the motor model. Browse gate remotes, photocells or control boards. If the old part is hard to identify, email sales@metalines.com with clear photographs of its label and the installed controller. We can help you narrow down the part before you order.

Find your model

Use the full model and part number, including any suffix, when comparing a new kit, motor or spare with equipment already installed. If the label is unclear, send us a photograph and we can help identify it.

Looking for Nice M-Fab?

M-Fab is an underground swing-gate range. If you are planning a new gate, compare underground gate kits. For an existing gate, the complete kit, motor, control board and replacement parts are different purchases: browse motors, control boards or spares. Keep the full model and part references so we can help you find the right item.